Whoops, fix a typo in my last commit.

[mmh] / INSTALL

diff --git a/INSTALL b/INSTALL
index 3cefafc..e946242 100644 (file)
--- a/INSTALL
+++ b/INSTALL
@@ -50,12 +50,10 @@ need an ANSI C compiler such as gcc.
 
 3) make
 
-4) make test
+4) make check
 
-   This takes a bit of time (under 2 minutes on a modern machine) but
-   is highly recommended.  "make test" copies your configuration and
-   rebuilds nmh completely in a sandbox, so you can test without
-   disturbing an existing nmh installation or any of your nmh folders.
+   This takes a bit of time, around one minute on a modern machine,
+   but is highly recommended.
 
 5) make install
 
@@ -98,9 +96,7 @@ need an ANSI C compiler such as gcc.
    rather than hardcoding pophost in `mts.conf'.
 
    Check the `mh-tailor' man page for a list of all the available options
-   for this file ("masquerade" may be of particular interest, though its
-   default value allows the most flexibility.  See the discussion of the
-   --enable-masquerade configure option below).
+   for this file.
 
 7) Edit the file `mhn.defaults' (installed in the nmh `etc' directory).
    This file contains the default profile entries for the nmh command
@@ -142,20 +138,14 @@ environment.  For example,
 
 If you wish to add options that are only used at compile time instead of
 link time, you can use the CPPFLAGS variable:
+
    ./configure CPPFLAGS='-Wextra -Wno-sign-compare'
 
 If you want to add to both compile and link flags at build time
-without putting them in the configuration, you can use an otherwise
-unused Makefile macro, like this:
-    make AM_CFLAGS=--coverage
+without putting them in the configuration, you can use the AM_CFLAGS
+Makefile macro:
 
-That does not include that setting in the configuration, so you will
-have to repeat it if you re-run "make".  One example would be if you
-build the test suite as a separate step:
-    make test AM_CFLAGS=--coverage
-
-Note that the Makefile test target depends on the default target, so
-both be can built in one step with "make test".
+    make AM_CFLAGS=--coverage
 
 ----------------------------------------
 Building nmh on additional architectures
@@ -204,19 +194,6 @@ Options for configure
 --enable-debug
      Enable debugging support.
 
---enable-masquerade[='draft_from mmailid username_extension']
-     By default, all three masquerade options are enabled.
-
-     If this option is disabled, the mts.conf file will contain the
-     line "masquerade: " (with no value), which may be manually edited
-     later.  You may find it convenient to specify a value at
-     configure-time, however, so that each time nmh is reinstalled,
-     the right value will be there.
-
-     See the mh-tailor(5) man page for full documentation of "masquerade:".
-
-     This option will likely be removed in a future version of nmh.
-
 --enable-pop
      Enable client-side support for pop.